97
Configuring the system settings
Gigaset DX600A isdn / IM-OST EN / A31008-N3101-R601-1-7619 / settings.fm / 05.03.2010
V
e
rsion 4, 16.0
9
.2005
Starting the firmware update
manually
v
¢
Ï
Settings
¢
System
Update Firmware
Select and press
§OK§
.
~
Enter the system PIN and
press
§OK§
.
The desktop phone establishes a connection
to the Internet.
§Yes§
Press the display key to start the
firmware update.
Automatic firmware update
Your desktop phone will check daily
whether a newer firmware update is availa-
ble from the Internet on the Gigaset config-
uration server. If firmware updates are avail-
able, the notification
New firmware availa-
ble. Update?
is displayed on the idle display
of the desktop phone and all registered
handsets and the message key
f
flashes.
f
Press the message key.
§Yes§
Press the display key to confirm
the prompt.
The firmware is loaded onto your desktop
phone.
You can deactivate the automatic version
check via the Web configurator.
Activating repeater support
You can increase the range and signal
strength of your desktop phone using a
repeater. You will need to activate repeater
mode. This will terminate any calls that are in
progress at the time.
Prerequisite:
Eco mode(+) is deactivated.
v
¢
Ï
¢
System
¢
Repeater Mode
§Change§
Press the display key to activate
or deactivate repeater mode
(
³
= on).
Activating/deactivating the
DECT interface
If there are no handsets or repeater regis-
tered to the desktop phone, then it is advis-
able to deactivate the desktop phone's
DECT interface.
v
¢
Ï
Settings
¢
System
¢
DECT Interface
§Change§
Press the display key to activate/
deactivate the DECT interface
(
³
= activated).
If you switch the desktop phone to registra-
tion mode
to reregister hand-
sets/repeater, the DECT interface is automat-
ically reactivated.
Please note
u
The firmware update can take up to
3 minutes.
u
When updating from the Internet,
checks are made to ensure that no
newer version of the firmware exists.
If this is not the case, the operation is
terminated and a message is issued to
that effect.
Please note
If the desktop phone is not connected to
the Internet at the time when the check
for new firmware is to be carried out (e.g.,
because the router is deactivated), the
check is carried out as soon as the desk-
top phone is reconnected to the Internet.
Please note
u
Repeater support and Eco/Eco+
mode
cancel each
other out i.e., both functions cannot
be used at the same time.
u
Switch all registered handsets off and
on again once the repeater has been
activated/deactivated.
