Te
mplat
e
M
odu
le
, V
e
rs
ion 1.
3,
1
1
.04.
20
19,
Additional functions
Gigaset A690IP-AS690IP / LUG-IP MEA en / A31008-M2813-A601-1-UZ19 / applications_IP.fm / 10/30/19
44
Sending an SMS via another SMS centre
¤
Activate SMS service centre 2, 3 or 4 as the active send service centre.
¤
Send the SMS.
This setting only applies to the next SMS sent. Afterwards, the
Service Centre 1
setting is used
again.
SMS to PABXs
You can only receive an SMS when
Calling Line Identification
is forwarded to the extension on
the PABX
(CLIP).
The CLIP of the phone number for the SMS centre is evaluated in your
Gigaset
.
Depending on your PABX, you may have to put the access code (outside line code) before the
number of the SMS centre.
If in doubt, test your PABX, e.g. by sending an SMS to your own number, once with the access
code and once without.
When you send SMS messages, your sender number may be sent without your extension
number. In this case the recipient cannot reply to you directly.
Enabling/disabling the SMS function
When you disable the SMS function, you cannot send or receive any further SMS messages with
your phone.
The settings you have entered for sending and receiving SMS messages (e.g. the numbers of the
SMS service centres) and the entries in the incoming and draft lists are saved even after deacti-
vation.
¤
Menu
Press the keys in sequence
SMS status report
If the function is activated, you will receive an SMS with status information from the SMS service
centre for each SMS that has been sent.
¤
Menu
SMS
OK
Settings
OK
Status Report
OK
(
= enabled)
If you have selected a VoIP connection and the attempt to transmit the SMS message
fails, the SMS is stored in the incoming message list with error status. Even if you have
enabled option
Automatic fallback to fixed line
(
p. 64), your phone will not
attempt to send the SMS over the fixed line network.
If the selected send connection is deleted from the configuration, the fixed line
network connection is used.
Deactivate the SMS function:
¤
OK
Activate the SMS function (default setting):
¤
OK