37
Environment
Gigaset A510H / Australia / A31008-M2252-C401-1-7619 / appendix.fm / 18.04.2012
V
e
rsion 4.1, 21
.11.2007
Questions and answers
If you have any queries about the use of your
telephone, visit our website at
www.gigaset.com/service
for assistance 24/7.
The table below also lists steps for trouble-
shooting.
Environment
Our environmental mission
statement
We, Gigaset Communications GmbH, bear
social responsibility and are actively com-
mitted to a better world. Our ideas, technol-
ogies and actions serve people, society and
the environment. The aim of our global
activity is to secure sustainable life resources
for humanity. We are committed to a respon-
sibility for our products that comprises their
entire life cycle. The environmental impact
of products, including their manufacture,
procurement, distribution, utilisation, serv-
ice and disposal, are already evaluated dur-
ing product and process design.
Further information on environmentally
friendly products and processes is available
on the Internet at www.gigaset.com.
The display is blank.
1. The handset is not activated.
¥
Press and
hold
the end call key
a
.
2. The battery is empty.
¥
Charge the battery or replace it
(
"Base"
flashes on the display.
1. The handset is outside the range of the base.
¥
Move the handset closer to the base.
2. The base's range is reduced because Eco
Mode is activated.
¥
Deactivate Eco Mode (
reduce the distance between the handset
and the base.
3. The base is not activated.
¥
Check the base power adapter.
4. Handset has not been registered with the
base or has been de-registered.
¥
Register the handset (
The handset does not ring.
1. The ringtone is switched off.
¥
Activate the ringtone (
2. The phone only rings if the phone number has
been transferred.
¥
Activate the ringtone for anonymous calls
(
The connection always terminates after
approx. 30 seconds.
Repeater activated/deactivated.
¥
Activate/deactivate the handset (
The other party cannot hear you.
You pressed the mute key
v
during a call. The
handset is "muted".
¥
Unmute the microphone (
The number of the caller is not displayed
although CLIP has been set.
Calling Line Identification is not enabled.
¥
The caller
should ask the network provider to
enable Calling Line Identification (CLI).
You hear an error tone when keying an input.
Action has failed/invalid input.
¥
Repeat the process.
Watch the display and refer to the user man-
ual if necessary.
Exclusion of liability
Some displays may contain pixels (pic-
ture elements), which remain activated or
deactivated. This is completely normal
and does not indicate a fault.