Gigamon GigaVUE TA Series, Hardware Installation Manual

Page: 54 / 108

54 GigaVUE TA Series Hardware Installation Guide
Figure 4-5: Connecting AC Power on a GigaVUE-TA200
2.
Plug the other end of the power cable(s) into a power source that can
supply adequate power.
N
OTE
:
If you are using the optional second power supply provided with
the node, plug the two power supplies into separate circuits for optimal
power protection.
For information on the GigaVUE TA Series power requirements, refer to
Power Requirements on page 90 .
N
OTE
:
The GigaVUE TA Series does not have power switches – once you
connect the system to power, it automatically powers on.
Refer to Connecting Serial Console and Mgmt Ports on page 57 for
information on how to connect to the GigaVUE TA Series command-line
interface (CLI).
Connecting -48V DC Power Supplies
The GigaVUE Traffic Aggregator is available with two DC power supplies
instead of the standard AC power supply. This section provides instructions
for connecting a -48V DC power source to the DC power supplies.