Basic GigaVUE H Series Connections and Configuration
89
You will also configure some Admin and Monitor level users with the procedure
described in
Initial User Account Configuration
Run the Jump-Start Script
Gigamon provides GigaVUE H Series nodes with a
jump-start
script that walks you
through the process of configuring basic settings. Run this script as follows:
1.
Switch to
Configure
mode.
The GigaVUE H Series provides three command entry modes, each with
increasingly powerful rights –
Standard, Enable,
and
Configure
. The jump-start
script is only available in Configure mode:
a.
Type
en <Enter>
to switch to Enable mode.
The system prompt changes from
[hostname]
>
to
[hostname]
#
.
b.
Type
config t <Enter>
to switch to Configure mode.
The system prompt changes from
[hostname]
#
to
[hostname]
(config) #
.
2.
Run the jump-start script with the following command:
(config) # config jump-start
3.
Follow the jump-start script’s prompts to configure each of the settings listed in the
following table.
N
OTE
:
If you change your mind about a particular setting, you will have a chance to
change it at the end of the script.
Hostname
The hostname appears in the system prompt and is used to
identify the chassis in SNMP traps.
Management Port Network
Settings
Use either DHCP or specify a static IP address and netmask. If
you do not use DHCP, you are prompted to configure the following
additional options:
•
Default Gateway
Supply the IP address of the default gateway for the node.
•
DNS Server
Supply the IP address of the DNS server for the node. A valid
DNS server is required for successful use of both Telnet and
.
•
Domain Name
Supply the domain name for the node (for example,
mycompany.com).
Enable IPv6?
You can enable the use of IPv6 for the management port. IPv6 is
used in addition to IPv4 if you enable this option. If you enable the
IPv6 you have the option of enabling IPv6 auto-configuration or
specifying a static address.
Security Settings
Enable the following security settings:
•
secure cryptography mode
•
secure passwords mode
•
minimum password length
Refer to the
GigaVUE-OS CLI Reference Guide
for information on
security.
Summary of Contents for GigaVUE-HC3
