Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 130 / 142

130 GigaVUE-HC3 Hardware Installation Guide
Node in Inband Cluster
The following procedure is to replace the control card on a GigaVUE-HC3 node in an
inband cluster.
Use the show chassis command to record the GigaVUE-HC3 chassis box ID and the
show cluster config command to record the cluster ID, cluster name, cluster master
address vip, cluster master preference, and cluster interface.
To replace a control card in a GigaVUE-HC3 that is in an inband cluster:
1.
On the cluster master node, backup the entire configuration on the cluster to a text
file.
(config) # configuration text generate active running upload <ftp | tftp | scp | sftp>://<upload URL>/
<profilename.txt>
2.
On the cluster master node, remove the configuration of the GigaVUE-HC3 node
from the cluster database. The commands may vary depending on your
configuration.
(config) # no map all
(config) # no gsop all
(config) # no vport all
(config) # no tunnel all
(config) # no gsgroup all
(config) # no stack alias <alias>
3.
On the GigaVUE-HC3 node, issue the following commands:
(config) # no cluster enable
(config) # write memory
4.
On the cluster master node, remove the GigaVUE-HC3 node information from the
cluster database. Answer YES when prompted. This removes the GigaVUE-HC3
from the cluster.
(config) # no chassis box-id <box ID>
WARNING !! All the cards, ports, and traffic configuration will be lost.
Enter 'YES' to confirm this operation: YES
5.
Replace the control card by following the procedure for Standalone Node on
page 127 up to and including Step 11 . (Since the GigaVUE-HC3 has been
removed from the cluster, it is a standalone node.)
6.
When the GigaVUE-HC3 is back up, reinstate the original cluster configuration
including the cluster ID, cluster name, cluster master address vip, cluster master
preference, and cluster interface, as well as the chassis box ID. Then reinstate the
interface configuration, chassis and card configuration, and GigaStream
configuration used for the inband cluster stack links.
The cluster configuration is as follows:
(config) # cluster id <cluster ID>
(config) # cluster name <cluster name>
(config) # cluster master address vip <cluster master vip>
(config) # cluster interface <interface>
(config) # cluster master preference <preference number for master, standby, or normal>
The interface configuration is as follows:
(config) # no interface eth1 zeroconf
(config) # no interface eth2 zeroconf
(config) # interface inband zeroconf