The four memory sockets are divided into two channels and each channel has two memory sockets as following:
Channel A: DDR4_2, DDR4_4
Channel B: DDR4_1, DDR4_3
Procedure and driver screen for enabling CrossFire/SLI technology may differ by graphics cards and driver version.
Refer to the manual that came with your graphics cards for more information about enabling CrossFire/SLI technology.
1-5
Installing an Expansion Card
Read the following guidelines before you begin to install an expansion card:
•
Make sure the motherboard supports the expansion card. Carefully read the manual that came
with your expansion card.
•
Always turn off the computer and unplug the power cord from the power outlet before installing an
expansion card to prevent hardware damage.
B. Connecting the Graphics Cards
Step 1:
Observe the steps in "1-5 Installing an Expansion Card" and install CrossFire/SLI graphics cards on the PCI
Express x16 slots. (To set up a 2-Way coniguration, we recommend installing the graphics cards on the
PCIEX16 and PCIEX8 slots.)
Step 2:
Insert the CrossFire
(Note 2)
/SLI bridge connectors in the CrossFire/SLI gold edge connectors on top of the cards.
Step 3:
Plug the display cable into the graphics card on the PCIEX16 slot.
1-6
Setting up AMD CrossFire
™
/NVIDIA
®
SLI
™
Coniguration
A. System Requirements
-
Windows 10 64-bit operating system
-
A CrossFire/SLI-supported motherboard with two or more PCI Express x16 slots and correct driver
-
CrossFire/SLI-ready graphics cards of identical brand and chip and correct driver (For the latest GPUs that
support the 3-way CrossFire technology, please refer to the AMD website.)
(Note 1)
-
CrossFire
(Note 2)
/SLI bridge connectors
-
A power supply with suficient power is recommended (Refer to the manual of your graphics cards for the
power requirement)
C. Coniguring the Graphics Card Driver
C-1. To Enable CrossFire Function
After installing the graphics card driver in the operating system, go to the
AMD RADEON SETTINGS
screen.
Browse to
Gaming\Global Settings
and ensure
AMD CrossFireX
is set to
On
.
C-2. To Enable SLI Function
After installing the graphics card driver in the operating system, go to the
NVIDIA Control Panel
. Browse to the
Conigure SLI, Surround, Physx
screen and ensure
Maximize 3D performance
is enabled.
(Note 1) When using dual core graphics cards, only 2-way is supported.
(Note 2) The bridge connector(s) may be needed or not depending on your graphics cards.
Dual Channel Memory Conigurations Table
DDR4_4
DDR4_2
DDR4_3
DDR4_1
2 Modules
- -
DS/SS
- -
DS/SS
DS/SS
- -
DS/SS
- -
4 Modules
DS/SS
DS/SS
DS/SS
DS/SS
(SS=Single-Sided, DS=Double-Sided, "- -"=No Memory)
Due to CPU limitations, read the following guidelines before installing the memory in Dual Channel mode.
1. Dual Channel mode cannot be enabled if only one memory module is installed.
2. When enabling Dual Channel mode with two or four memory modules, it is recommended that memory
of the same capacity, brand, speed, and chips be used.
- 11 -