BIOS Setup
- 143 -
5-9 Save & Exit Menu
The Save & Exit menu displays the various options to quit from the BIOS setup. Highlight any of the exit
options then press <Enter>
.
Parameter
Description
Save Options
Save Changes and Exit
Saves changes made and closes the BIOS setup.
Options available: Yes, No.
Discard Changes and Exit
Discards changes made and exits the BIOS setup.
Options available: Yes, No.
Save Changes
Saves changes done so far to any of the setup options.
Options available: Yes, No.
Default Options
Restore Defaults
Loads the default settings for all BIOS setup parameters. Setup Defaults
are quite demanding in terms of resources consumption. If you are using
low-speed memory chips or other kinds of low-performance components
and you choose to load these settings, the system might not function
properly.
Options available: Yes, No.
Boot Override
Press [Enter] to configure the device as the boot-up drive.
Launch EFI Shell from
filesystem device
Attempts to Launch EFI Shell application (Shell.efi) from one of the
available file system devices.
Summary of Contents for R272-Z30
