Gigabyte R183-Z91, User Manual, Page: 21 / 165

System Appearance
- 21 -
2-6 Hard Disk Drive LEDs
3.5" Hard Disk Drive
LED #1
LED #2
2.5" 9.5mm Hard Disk Drive
/('
/('
LED #2 HDD Present No HDD
Green ON OFF
NOTE:
* 1: Depends on HBA/Utility Spec.
*2: Blink cycle depends on HDD's activity signal.
*3: If HDD is pulled out during rebuilding, the disk status of this HDD is regarded as faulty.
RAID SKU
LED #1 Locate
HDD
Fault
Rebuilding HDD Access HDD Present
(No Access)
No RAID
configuration
(via HBA)
Disk LED (LED
on Back Panel)
Green ON(*1) OFF BLINK (*2) OFF
Amber OFF OFF OFF OFF
Removed HDD
Slot (LED on
Back Panel)
Green ON(*1) OFF -- --
Amber OFF OFF -- --
RAID
configuration
(via HW RAID
Card or SW
RAID Card)
Disk LED
Green ON OFF BLINK (*2) OFF
Amber OFF ON
(Low Speed:
2 Hz)
OFF OFF
Removed
HDD Slot
Green ON(*1) OFF (*3) -- --
Amber OFF ON (*3) -- --