Gigabyte H242-Z10, User Manual, Page: 119 / 139

- 119 - BIOS Setup
ABL Mem - Before OtherTiming 0xE04A
ABL Mem - Before UMAMemTyping 0xE04B
ABL Mem - Before SetDqsEccTmgs 0xE04C
ABL Mem - Before MemClr 0xE04D
ABL Mem - Before On DIMM Thermal 0xE04E
ABL Mem - Before DMI 0xE04F
ABL MEM - End of phase 3 memory code 0xE050
5-10-5 CPU test points
Entry point CPU init after training 0xE051
Exit point CPU init after training 0xE052
Entry point CPU APOB CCX map init 0xE053
Exit point CPU APOB CCX map init 0xE054
Entry point CPU Optimized boot init 0xE055
Exit point CPU Optimized boot init 0xE056
Entry point CPU APOB EDC info init 0xE057
Exit point CPU APOB EDC info init 0xE058
5-10-6 Topology test points
ProcTopologyEntry 0xE071
ProcTopologyDone 0xE07C
5-10-7 Extended memory test point
ProcMemSendMRS2 0xE080
Sedding MRS3 0xE081
Sending MRS1 0xE082
Sending MRS0 0xE083
Continuous Pattern Read 0xE084
Continuous Pattern Write 0xE085
Mem: 2d RdDqs Training begin 0xE086
Mem: Before optional callout to platform BIOS to change External
Vref during 2d Training
0xE087
Mem: After optional callout to platform BIOS to change External
Vref during 2d Training
0xE088
Configure DCT For General use begin 0xE089
Configure DCT For training begin 0xE08A
Configure DCT For Non-Explicit 0xE08B
Configure to Sync channels 0xE08C
Allocate C6 Storage 0xE08D
Before LV DDR4 0xE08E
Before LV DDR3 0xE08F