Gigabyte GA-990FXA-UD7, User Manual, Page: 77 / 112

- 77 - Configuring SATA Hard Drive(s)
C. Rebuilding an Array
Rebuilding is the process of restoring data to a hard drive from other drives in the array. Rebuilding applies
only to fault-tolerant arrays such as RAID 1, RAID 5, and RAID 10 arrays. To replace the old drive, make sure
to use a new drive of equal or greater capacity. The procedures below assume a new drive is added to replace
a failed drive to rebuild a RAID 1 array.
For the AMD SB950:
While in the operating system, make sure the Chipset driver has been installed from the motherboard driver
disk. Then install the AMD RAID Utility (go to Application Software\Install Application Software and select AMD
RAID Utility to install). Then launch the AMD RAIDXpert from All Programs in the Start Menu .
Step 1:
Enter the login ID and password (default: "admin"),
and then click Sign in to launch AMD RAIDXpert .
Step 2:
Select the RAID array to be rebuilt under
Logical
Drive View and click the Rebuild tab in the Logical
Drive Information pane.
Step 3:
Select one available drive and click
Start Now to
start the rebuilding process.
Step 4:
The rebuilding progress is displayed on the screen
and you can select
Pause / Resume / Abort during
the rebuilding process.
Step 5:
When done, the array's status on the
Information page
in the Logical Drive Information pane will display as
Functional .