Gigabyte G492-Z52, User Manual, Page: 29 / 137

- 29 -
System Hardware Installation
3-5 Installing the PCI Expansion Card
Read the following guidelines before you begin to install the PCI expansion card:
• Voltages can be present within the server whenever an AC power source is connected. This
voltage is present even when the main power switch is in the off position. Ensure that the
system is powered-down and all power sources have been disconnected from the server prior to
installing a PCIe card.
• Failure to observe these warnings could result in personal injury or damage to equipment.
Follow these instructions to install the PCI Expansion card:
1. Pull out the thumbnail screw securing the GPU card cage in place.
2. Flip over the GPU card cage in the direction indicated.
3. Remove the two screws securing the PCIe card slot covers in place and remove the PCIe card slot
covers.
4. Insert the PCIe card into the selected slot. Make sure the PCIe card is properly seated.
5. Install the two screws to secure the PCIe card in place.
6. Reverse the previous steps to remove the PCI expansion card.
1
2