GIGA-BYTE TECHNOLOGY R281-2O0, Service Manual

Page: 23 / 124

- 23 - Hardware Installation
2-5 Hard Disk Drive LEDs
LED 2 HDD Present No HDD
Green
ON
OFF
NOTE!
(*1) Depend on HBA/Utility Spec
(*2) Blink cycle depend on HDD’s activity signal.
(*3) If HDD is pulled out during rebuilding, Disk status of this HDD is regarded as fault
LED#1 LED#2
RAID SKU
HDD Fault Locate
HDD
Access
HDD Present
(No Access)
No RAID configuration
(via HBA, PCH)
RAID configuration
(via HW RAID Card or
SW RAID Card)
Disk LED
(LED on
Back Panel)
Amber
Removed HDD Slot
(LED on Back Panel)
Disk LED
Removed HDD Slot
Green
ON(*1) OFF BLINK (*2)
BLINK (*2)
OFF
OFF
OFF
ON
OFF
ON(*1)
OFF
OFF
ON
OFF
ON
(Low Speed: 2 Hz)
(*3)
(*3)
OFF
OFF
--
--
Green
Amber
Green
ON(*1) OFF --
--
--
--
--
Green
OFF OFF -- Amber
Amber OFF OFF
Rebuilding
OFF
LED1