- 123 -
BIOS Setup
ABL Mem - Before OtherTiming
0xE04A
ABL Mem - Before UMAMemTyping
0xE04B
ABL Mem - Before SetDqsEccTmgs
0xE04C
ABL Mem - Before MemClr
0xE04D
ABL Mem - Before On DIMM Thermal
0xE04E
ABL Mem - Before DMI
0xE04F
ABL MEM - End of phase 3 memory code
0xE050
5-10-5 CPU test points
Entry point CPU init after training
0xE051
Exit point CPU init after training
0xE052
Entry point CPU APOB CCX map init
0xE053
Exit point CPU APOB CCX map init
0xE054
Entry point CPU Optimized boot init
0xE055
Exit point CPU Optimized boot init
0xE056
Entry point CPU APOB EDC info init
0xE057
Exit point CPU APOB EDC info init
0xE058
5-10-6 Topology test points
ProcTopologyEntry
0xE071
ProcTopologyDone
0xE07C
5-10-7 Extended memory test point
ProcMemSendMRS2
0xE080
Sedding MRS3
0xE081
Sending MRS1
0xE082
Sending MRS0
0xE083
Continuous Pattern Read
0xE084
Continuous Pattern Write
0xE085
Mem: 2d RdDqs Training begin
0xE086
Mem: Before optional callout to platform BIOS to change External
Vref during 2d Training
0xE087
Mem: After optional callout to platform BIOS to change External
Vref during 2d Training
0xE088
Configure DCT For General use begin
0xE089
Configure DCT For training begin
0xE08A
Configure DCT For Non-Explicit
0xE08B
Configure to Sync channels
0xE08C
Allocate C6 Storage
0xE08D
Before LV DDR4
0xE08E
Before LV DDR3
0xE08F
Summary of Contents for G292-Z20
