8
Start up
The espresso machine KJS2 is to be installed to comply with the applicable federal, state or local
plumbing codes having jurisdiction exclusively by authorised technical service.
Open the water tap and switch on the main electrical switch.
Turn the on/off switch (fig. 1,4) from position 0 to position 1.
At the first start up the boiler is empty and therefore the automatic water refill system starts.
Note: After
approx 180 “ the autorefill function stops. In case the boiler is not completely filled in, the leds on the
touchpad flash. In this case turn again the on/off switch (fig.1.4) on 0 and then 1 to begin again the filling.
Turn the on/off switch on position 2. to begin the heating.
Wait till the boiler pressure has reached the working pressure (0.9 bar approx). You can check it on the
gauge (fig, 1.8).
Open the steam tap ( fig. 1,1) for some seconds and then close it. This operation avoids milk sucking in the
boiler. As the above operation causes pressure reduction in the boiler, wait till the working pressure is
reached again .
Your machine is now ready to work.
Operation
Insert the lower filter in the filter holder with
1 spout to prepare 1 cup of espresso.
Fill with 6/7 gr. appr. of grinded coffee and
tamp it..
Insert the higher filter in the filter holder with
2 spouts to prepare 2 cups of espresso.
Fill with 12/14 gr. appr. of grinded coffee and
tamp it..
To begin the erogation of the espresso, insert the filter holder ( fig.1,7) into the coffee brewing group
(Fig.1,6).
Put the cups beneath the spouts and press the key corresponding to the wished selection (only for
automatic version).
GGM Gastro International GmbH | Weinerpark 16 | 48607 Ochtrup
Tel.: 02553 / 72 20 0 | Fax: 02553 / 72 20 20 0 | Mail: [email protected]
www.ggmgastro.com
