Gfp 300 Series
January 2019
23
18. Mounting
A. Pre-coating mounting boards
•
Load a roll of mounting adhesive on the top roller
(see Loading upper shafts section 11)
•
Insert leader board the same thickness as the board to be coated and the
width of the mounting adhesive, between the nip rollers and lower the
top roller until it touches the board
•
Pull mounting adhesive down over the idler bar and over the front of nip
roller and adhere to the leader board
•
Run leader board half way through the roller and stop
•
Insert mounting board to be coated and depress foot switch
•
After the last board, insert leader board to keep adhesive from contacting
the rollers
B. Mounting print to a pre-coated mounting board
•
Pull back and fold down 1” of the liner from the pre-coated mounting
board
•
Adhere leading edge of the print to the exposed adhesive on the board
•
Insert leading 1” of the board into the nip rollers
•
Lower the roller
•
Lay print over top nip roller
•
Hold release liner on board with one hand and apply pressure to print as
it comes over the top roller.
•
Depress the foot switch to run the board and print through the rollers
