6
Peakanalyzer Installation Manual Version 2.6
(applied in Germany by the EMV-Gesetz)
*) changed by CE-Kennzeichnungsrichtlinie 93/68/EWG
The measurement system is developed and manufactured by the following guidelines:
Sicherheitsbestimmungen für elektrische Mess-, Steuer-, Regel- und Laborgeräte DIN
EN 61 010-1: 2002
It was tested with greatest care before delivery and was shipped in perfect condition.
1.3
Notes to radio interference suppression
The Peakanalyzer fulfills the EMV-policy for unlimited usage in living area and industrial area
in a regular installed state. The Peakanalyzer in an IP65 box must have the door closed when
it is in operational state.
All additional products that are connected to the device must be also suppressed by radio
interference according to BMPT-Vfg. Nr. 1046/84 or Nr. 243/91 or EG-Richtlinie 89/336/EWG.
Products that fulfill the requirement are labeled with a CE-Label or a label describing the
suppression of radio interference by the manufacture.
Products that do not fulfill the requirements can only be used with an individual license of the
BZT.
All signal cables that are connected to the Peakanalyzer must be shielded and the shield must
be connected to protected earth. If the Peakanalyzer is delivered in an IP65 box, the shield of
the signal cables must be connected to the bulkhead receptacle. If the signal cable is directly
connected to the measurement terminal, the shield can alternatively be connected to the clamp
with a black S on yellow ground.
Please consider that all signal inputs and outputs except the power connection is shielded and
must be connected to protected earth on one side. Only in this case a high interference
immunity and interference emission can be achieved.
1.4
FCC-Note
This device has fulfilled all thresholds in tests that are formalized in chapter 15 of the FCC-
Guideline (in 47 CFR 15.105)
4
for digital devices of the class B. These thresholds have
sufficient protection of harmful radiation for the installation in living areas. Devices of this class
generate and use high frequency electromagnetic waves and may emit these. Thus if the
instructions are not realized properly it is possible to disturb the radio reception. However in
exceptional cases certain installations can cause disturbances. If the radio or TV reception is
disturbed and it can be backtracked to the device by switching it off and on it can be corrected
by the following actions:
•
Adjust the direction of the receiver
•
Increase the distance between the device and the receiver
•
Plug in the power connector of the device in another socket so that the device is connected
to a different electrical circuit than the receiver.
4 FCC - United States Federal Communications Commission