Peakanalyzer Installation Manual Version 2.6
39
5
Completion of the Installation
This chapter describes how the correct connection of all sensors can be verified via a service
measurement triggered in Peakanalyzer Manager.
The service measurement allows a simultaneously measurement of 8 channels on the
Peakanalyzer. The desired sensors can be selected on the right side bar besides the curve
window. The time signals produced by the sensors are shown in the curve window after the
start of a measurement and thus can be verified.
Picture 30: service measure
One requirement for the start of a service measurement is an active monitoring configuration
on the Peakanalyzer. Normally this is the case since the delivered Peakanalyzer at least
contains a configuration with the corresponding sensor settings. These sensor settings are
also used for the service measurement. Mostly there is also a complete monitoring
configuration on the Peakanalyzer with complete kinematic data of the machine.
The setup and handling of the software Peakanalyzer Manager is described in detail in the
Manual Peakanalyzer Manager. The chapter 6 describes the creation and transmission of a
monitoring configuration whereas chapter 7 provides detailed information of a service
measurement.