gfm GF-Primo Dolly, Instruction Manual And Safety Manuallines

Page: 36 / 92

35
Info: Shortly after switching on, the LED on the electronic will blink alternatively
from red/green. The HCU Display and the LED on the HCU will show up in
red. After approx.. 2 seconds both LEDs will show green and the HCU display
will alight in blue.
Both the electronic unit and HCU now exchange identification numbers,
excepting the respective data.
9.2
Pairing in wirelss mode
Pairing the HCU and electronic can also be done in wireless mode. Both units must be tuned to the
same channel. If they a
re not please see the section “8 Synchronising the channels”.
Info:
If the HCU and electronic are already paired in cable mode, they do not require additional
pairing in wireless mode.
Proceed as follows:
Press and hold the LIMIT-button pressed, the switch on the HCU by pressing the ON/OFF
button.
GET NEW DOLLY
– will appear on the display. The dolly electronic should be switched off.
Confirm that the electronic is switched off and press the ENTER button.
Now switch on the electronic.
The HCU display will show „FOUND DOLLY WOULD YOU ACCEPT“.
Confirm by pressing the ENTER-button.
A successful pa
iring will be confirmed by „PAIRED SUCCESSFULLY NEW DOLLY“showing
on the HCU display. Then press EXIT.
Display off
Display red
Display blue (ready)