Slimdrive SLT product family
31
Troubleshooting
8
Troubleshooting
8.1 Mechanical faults
Cause
Remedy
Track bent
X
Replace the track
X
Check the installation surface
Moving leaf stiff
X
Check the moving leaf (see Chapter 8.1.1)
Roller carriage jammed or defective, high abrasion on
the track rollers
X
Replace the track roller (see Chapter 8.2),
clean the track
Tooth belt damaged
X
Replace the tooth belt
8.1.1 Checking the moving leaf
X
Disconnect the moving leaf from the toothed belt using the toothed belt locking.
X
Move the moving leaf and check for ease of movement.
If moving leaves move easily:
X
Check the motor gear unit and deflection pulley and replace if necessary.
8.2 Replacing roller carriage
WARNING!
Risk of injury caused by moving leaf falling over!
The moving leaves are very heavy.
X
At least 2 people should work together to set up the moving leaf.
WARNING!
Risk of injury due to glass breakage.
X
At least 2 people should work together to set up the moving leaf.
X
Remove the cap, if necessary only unscrew the
side plates.
X
With inner moving leaves, loosen the driver
from the toothed belt locking.
X
Loosen lock nuts (1).
X
Remove the moving leaf (2) from the suspension
and secure.
X
Move the roller carriage out at the side.
X
Remove the wire cable for the outer moving
leaf, see Chapter 5.4.4.
X
Loosen lock nuts (1).
X
Remove the moving leaf (2) from the suspension
and secure.
X
Replace roller carriage.
X
Install the roller carriage and moving leaf in the
reverse order.