Slimdrive SLT product family
30
Service and maintenance
7.2 Maintenance
CAUTION!
Risk of injury due to impact and crushing!
X
Secure door leaves against accidental movement.
X
Disconnect rechargeable battery.
X
Disconnect the mains voltage.
à
Only original replacement parts may be used.
à
To ensure proper function, the wear parts of the sliding door system must be inspected and exchanged if necessary
during every maintenance.
à
The prescribed maintenance work on the sliding door system must be handled by an expert:
à
at least once a year
or
à
When the service indicator on the programme switch lights up (see wiring diagram).
à
Not all wear parts listed may be present, depending on the configuration.
X
Provide test documents and keep them up-to-date.
Wear parts present
Exchange interval
Rechargeable battery
Two years
Roller carriage track and support rollers
In case of wear or damage
Cleaning and sealing brushes
In case of wear or damage
Tooth belt
In case of wear or damage
Floor guide
In case of wear or damage
Deflection pulleys
In case of wear or damage
Motor gear unit
In case of wear or damage
Cover fixing
In case of wear or damage
Rubber cable
In case of wear or damage
Pulleys for rubber cable
In case of wear or damage
After completing the maintenance work, always execute the learning function for the door.
Tested component
Action
Comments
Track
Check for cracks
X
Replace the track
Check for cleanliness
X
Clean the track
Roller carriage
Check the abrasion of the track rollers
X
Remove the abrasion
Floor guide area
Check for jarring-free function
X
Clean floor guide area
Floor guide area (brushes)
Check for contamination and hardness
X
Clean or replace
Moving leaf
Check for smooth movement
X
See Chapter 8.1.1
Tooth belt
Check for wear & tear and damage
X
If necessary, replace the tooth belt(see Chapter 5.5)
Check tension
X
If necessary, tighten the tooth belt (see Chapter 5.5.1)
Check tooth belt locking mechanism
(optional) for damage
X
Re-position the tooth belt locking mechanism
(optional) if necessary (see Chapter 5.5.3)
Tooth belt locking
mechanism (optional)
Check function
X
Re-position the tooth belt locking mechanism
(optional) (see Chapter 5.5.3)
Screws
Check for tight fit
X
Tighten the screws if (refer to drive drawing
for torques)
Assembly groups and
peripherals
Check for correct function
X
Replace assembly group
Cables
Check for damage and correct
fastening
X
Fasten or replace cables