Slimdrive SLT product family
21
Installation
5.5.3 Positioning the tooth belt locking mechanism (optional)
X
Close the moving leaves.
X
Loosen the screws (1) at the tooth belt locking
mechanism (optional).
X
Align the locking device to the toothed belt.
Following installation, the locking pin (2) must be positioned in the hole in the cover so that the tooth belt locking
mechanism can be locked and unlocked.
X
If necessary enlarge the drill hole.
X
Tighten screws (1).
X
Adjust the locking guide (4) so that the
tooth belt neither touches nor has too
much clearance. To do this, loosen 2
screws (3), move the locking guide (4) and
re-tighten the screws (3) (torque 5 Nm).
The driver must not come into contact with the tooth belt locking mechanism (optional) during operation.
X
After the tooth belt has been installed, check (click) the switching points of the indicator switches of the tooth
belt locking mechanism (optional). Adjust by bending the actuator levers, if necessary.