GEZE Powerturn, Installation And Service Instructions Manual

Page: 26 / 56

Powerturn
26
Installation
7.3 Preparing the electrical connection
X
Lay the 230 V connection cable (1) flat above
the plug connection (2).
X
For further working steps, see the wiring
diagram Powerturn, mat. no. 154919.
7.4 Preparing the drive
à
For the correct position and alignment of the drive, see chapter 6.2.
X
At the drive, detach the clamping claw (3) located on the lower side after the drive has been installed.
X
Only loosen the clamping claw by approx. 3–6 mm otherwise the flat ribbon cable could slip out of the clamp-
ing claw (3).
Danger of crushing the cable.
X
Remove the e-cover (1).
X
Undo the 2 screws (4) on the lower clamping
claw (3).
X
Unscrew and keep the screw (2) M6 × 40.