Teach-in
GC 342 safety sensor
24
10.4 Test and settings
Checking the correct positioning of the detection areas
X
Place a reference body in the
detection area.
The door swings open up to the
reference body without touching
it and then closes again.
X
Place the reference body next
to the door leaf.
The door does not move.
30 cm 20 cm
70 cm
If necessary, set the inclination
angle of the sensor:
X
Turn the angle adjustment screw
(between 2° and 10°).
A
A
B
B
If the inclination angle, starting position or environment has been changed, always
launch a teach-in and test the correct positioning of the detection areas checked.
Summary of Contents for GC 342
Page 1: ...EN Installation and operating instructions GC 342 safety sensor 167391 03 47 0159 V3 12 19...
Page 9: ...9 Installation GC 342 safety sensor 1 2 2 mm 5 mm 2 PZ2 3...
Page 11: ...11 Installation GC 342 safety sensor DIP ON 1 2 3 4 1 2 6 DIP ON 1 2 3 4 PZ1 1 2 7...
Page 19: ...19 Parameter setting GC 342 safety sensor SIO SIS SIS SIS SIS SIO SIS SIS SIS SIO SIS SIO...
