GEZE hold-open system FA GC 150
18
Technical data
4.5.2 “Set up wireless connection” mode
In the “set up wireless connection” mode, new wireless connections can be set up to new wireless devices GC
172, GC 173 or GC 175. A maximum of 6 wireless connections can be set up.
Pre-conditions
ú
All the wireless device switches of the wireless module GC 171
are in the OFF position.
SW1x
ú
The set-up switch of the new wireless device is set to the
ON position.
ú
The protective film is on the battery compartment of the
new wireless device and the main battery for the new
wireless device has not been fitted.
After the supply voltage has been switched on, the wireless
module GC 171 is in “operating” mode.
X
Press the PB1 push button on the wireless module GC 171
briefly to change to the “set up wireless connection” mode.
The status LED2 of the wireless module GC 171 is now
permanently lit red.
KL1
SW1
LED1
24V
GND
MRB
AS
1
2
3
4
LED2
PB1
SW2
GC161
GC151
KL1
SW1
LED1
24V
GND
MRB
AS
1
2
3
4
LED2
PB1
SW2
GC161
GC151
Set up wireless connection
X
Slide a free wireless device switch SW1x of the wireless
module GC 171 to the ON position.
If a connection has already been set up for the wireless
device switch selected, this is overwritten by the follow-
ing process. The corresponding wireless device LED1x
starts to flash green. The wireless module GC 171 waits
for the connection query for a new wireless device. If a
wireless device does not
respond
within 2 minutes, the
GC 171 cancels the connection attempt, the correspond-
ing wireless device LED1x lights up red.
X
To start the connection attempt again, slide the cor-
responding wireless device switch SW1x to the OFF posi-
tion briefly, then slide it back into the ON position.
The corresponding wireless device LED1x flashes green
again for 2 minutes.
LED1x
SW1x
Install batteries
X
Remove the protective film from the battery compart-
ment of the new wireless device and install the main bat-
tery in the new wireless device (ensure correct polarity).
