GLP
German Light Products GmbH
(instruction version
1.07)
24
4x
3. Open the four quick release fasteners (1, 2, 3 and 4) of the backside lamp
sheet and remove it carefully.
4. Remove the old or broken lamp from the two sidewise lamp clip fasteners.
Attention:
The glass bulb of the lamp can splinter. For that reason remove the
lamp with safety gloves or some cloth.
5. Put in the new lamp securely with a
tight fit into the socket (2x clip
fasteners). The lamp filler neck must
be towards the backside of the
reflector.
Attention:
Use only original
lamp types!
OK
NO
3
2
6. Pull the lamp holder sheet safely back in the shaft and close the four quick
release fasteners.
7. The running time of the lamp
LA1
can be reseed in the
Time
Menu.
5.3 Adjusting the lamp position (Hotspot)
You should adjust the lamp position after each lamp exchange. This is necessary
because each lamp has small fabrication variations and the illumination and
imaging of the fixture can be not optimal. For this purpose the YPOC is equipped
with an adjustment system of the lamp, consisting of two set screws on the
backside lamp sheet (set screw A and B). The lamp adjustment is a matter of the
users taste but will best be done as follows:
1. Move lamp with set screw B forewords/backwards until a very bright luminous
spot (hotspot) can been seen best.
2. Move lamp with set screw A upward/downwards until this hotspot is in the
center of the illumination.
3. Use again set screw B to move lamp forewords/backwards until you've
