R
R
R
-
-
-
G
G
G
-
-
-
B
B
B
Without mounting bar
2.2 Secure the Device
Regardless of the mounting method of the
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
you'll have to use a stipulated safety
wire. Therefore you have to pull the safety wire through to two provided holes on the bottom
side of the system and connect it with the truss-support. Pay attention to a safe and proper
fastening. Install a safety wire that can hold at least 10 times the weight of the fixture. Never use
the carrying handles for this purpose.
2.3 Connections
2.3.1 Power
Supply
~100-240 Volt AC, 50-60 Hz, earth contact type plug - Powercon
Connected load 1200 VA (W)
<=>
14 AT (micro-fuse 5x20mm)
Please see printing on the case for the right electronic supply!
Disconnect from the mains supply for changing the fuse and use only the above
described micro-fuse type.
2.3.2 DMX
USITT DMX-512 Standard input/output in 3 pole and 5 pole connectors.
Pin 1 = [Ground] / Pin 2 = [-] / Pin 3 = [+]
The DMX- Addressing starts at the DMX- Address [001].
GLP
German Light Products GmbH
(Manual Version 1. / from Software Version 1.09/0.3)
9
Summary of Contents for Impression XL
Page 2: ...For your notes ...
