R
R
R
-
-
-
G
G
G
-
-
-
B
B
B
5
5
Maintaining and Cleaning the
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
The
I
I
M
M
P
P
R
R
E
E
S
S
S
S
I
I
O
O
N
N
X
X
L
L
is a system of very low maintenance. It is only necessary to clean the air in-
and outlets as well as the optical LED lenses from time to time. For a safe operation it is absolutely
essential that the fixture is kept clean and that dust, dirt and smoke-fluid residues must not built up on
or within the fixture. Otherwise the fixture's light-output will be significantly reduced or damages can
occur. Regular cleaning will not only ensure the maximum light-output, but will also allow the fixture to
operate reliably throughout its life.
A soft lint-free cloth moistened with any good glass cleaning fluid is recommended, under no
circumstances should alcohol or solvents be used!
5.1 Safety
regulations
•
Pull out the main plug!
•
Wait min. 15 minutes after the last operation to cool down the fixture.
5.2 Circumference and Interval (rule-of-thumb)
The contamination of the fixture depends on the environment details. Hence no general
guidelines can be given. The intervals given below are only suggestions from our practice
experience.
Position
Interval
In this way
LED reflector and optical system
weekly
soft brush /lint-free cloth
Fan and air channel
monthly
vacuum cleaner, airbrush, etc.
Attention:
•
Never let optical parts come into contact with oil or fat.
•
Before running the fixture wait until all parts are dried up.
•
Never tough lenses with bare fingers.
GLP
German Light Products GmbH
(Manual Version 1. / from Software Version 1.09/0.3)
17
Summary of Contents for Impression XL
Page 2: ...For your notes ...
