GERATHERM desktop, Manual

Page: 40 / 164

40
EN
Annex
Guidance and manufacturer´s declaration – electromagnetic emissions
The device is intended for use in the electromagnetic environments listed below, and
should only beused in such environments:
Emissions test Compliance Electromagnetic environment - guidance
RF emissions CISPR 11 Group 1
RF energy is used only to maintain device’s
operation. Therefore, its RF emissions are so
low that it’s not likely to cause any interfer-
ence in nearby electronic equipment.
RF emissions CISPR 11 Class B
The device is suitable for use in all establish-
ments, including domesticestablishments,
and those directly connected to the public
low-voltage power supply networkthat sup-
plies buildings used for domestic purposes.
Harmonic emissions
IEC 61000-3-2
Class A
Voltage fl uctuations / fl icker
emissions IEC 61000-3-3
complies
Guidance and manufacturer´s declaration – electromagnetic emissions
The device is intended for use in the electromagnetic environments listed below, and
should only beused in such environments:
Immunity test
IEC 60601 –
test level Compliance
level Electromagnetic environment -
guidance
Electrostatic
discharge (ESD)
IEC 61000-4-2
± 6 kV contact
± 8 kV air ± 6 kV contact
± 8 kV air
Floors should be wood, concrete
or ceramic tile. If
fl oors are covered
with synthetic material, the relative
humidity should be at least 30 %.
Power frequency
(50/60 Hz)
magnetic
fi eld
IEC 61000-4-8
3 A/m 3 A/m
Power frequency magnetic fi elds
should be at levels characteristic of
a typical location in a typicalcommer-
cial or hospital environment.
Recommended separation distances between portable and mobile RF communication
The device is intended for use in an electromagnetic environment where radiated RF
disturbancesare under control. User can help prevent electromagnetic interference by
keeping the device at a minimum distance from portable and mobile RF communications
equipment (transmitters). Below table details the maximum output power of transmitter:
Rated maximum
output power
of transmitters
in Watt Seperation distance according to frequency of transmitter / m
150 kHz to 80 MHz
d = 1.2
√ P
80 MHz to 800 MHz
d = 1.2
√ P
800 MHz to 2.5 GHz
d = 2.3
√ P
0.01
0.1
1
10
100 0.12
0.38
1.2
3.8
12 0.12
0.38
1.2
3.8
12 0.23
0.73
2.3
7.3
23
For transmitters rated at a maximum output power not listed above, the recommended
separation distance d in metres (m) can be estimated using the equation applicable to the
frequency of the transmitter, where P is the maximum output power rating of the transmit-
ter in watts (W) according to the transmitter manufacturer.
NOTE 1:
At 80 MHz and 800 MHz, the separation distance for the higher fre-
quency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic
propagation is affected by absorption and re
fl ection from structures,
objects and people.