Getting Started
9
2
Connection Failed
Unable to connect to the camera. Move the cursor onto the red
icon to see the error message.
Inactive Camera
The camera is inactive. Click the checkbox to connect.
Started Monitoring
The camera is under monitoring.
Pre-Rec Enabled
Pre-recording is enabled.
4. To adjust camera settings, click
Setup
next to the camera. Refer to
3.2 Configuring
Camera Settings
for details.
5. Close the dialog box by clicking X in the top-right corner. When adding camera for the
first time, the cameras will be automatically assigned to the live view grid.
Note:
1. You can also access the IP Device Setup dialog box by clicking
Home
>
Toolbar
>
Configure
>
Camera Install
.
2. If your camera was not detected during the scan in Automatic Setup, you can click the
Manual Setup
button to type the camera connection information manually.
2.2 Accessing Camera Live View
After adding cameras, you can access camera live view by dragging the camera in the
Content List to the live view grid.
Click
Home
>
Toolbar
>
Content List
. Then click
Camera
to see the list of
cameras added, and drag the desired cameras to the live view grid.
For details, see
Chapter 4 Live View
in this Quick Start Guide.