47
5.4.7 Face Detection
Face detection function is to detect the face appearing in the surveillance scene. Alarms will
be triggered when a face is detected.
The setting steps are as follows:
1. Go to Config
→
Event
→
Face Detection as shown below.
2. Enable the face detection function.
Save Source Information:
if checked, the whole picture will be saved to the SD card when
detecting a face.
Save Face Information
: if checked, the captured face picture will be saved to the SD card
when detecting a face.
Note
: To save images to the local PC, please enable the local smart snapshot storage first
(Config
→
System
→
Local Config). To save images to the SD card, please install an SD card
first.
Trigger alarm condition
: all alarms or mask off can be selectable.
All alarms:
Alarms will be triggered when the camera detects a face (with/without a mask).
Mask off:
Alarms will be triggered when the detected person is not wearing a mask on the
face.
3. Set the alarm holding time and alarm trigger options. The alarm trigger setup steps are the
same as fire detection setup. Please refer to
Fire Detection
chapter for details.