GeoVision GV-TMEB5800, User Manual, Page: 42 / 86

33
Cable Disconnection
1. Go to Config
→
Alarm
→
Anomaly
→
Cable Disconnected as shown below.
2. Click
“Enable” and set the alarm holding time.
3. Trigger alarm out. When the camera is disconnected, the system will trigger the alarm out.
5.3.3 Alarm In
To set sensor alarm (alarm in):
Go to Config
→
Alarm
→
Alarm In interface as shown below.
1. C
lick “Enable” and set the alarm type, alarm holding time and sensor name.
2. Set alarm trigger options. The setup steps are the same as fire detection. Please refer to
Fire Detection chapter for details.
3.
Click “Save” button to save the settings.
4. Set the schedule of the sensor alarm. The setup steps of the schedule are the same as
the schedule recording setup. (See Schedule Recording ).
If there are two sensors, please select the sensor ID. C
lick “Apply settings to” to quickly apply
the settings to the other alarm input.