GV-GPS Receiver
Installation Guide
The GV-GPS Receiver can work with GV-Video Server and GV-Compact DVR to perform GPS
vehicle tracking.
Packing List
• GV-GPS Receiver x 1
• Suction Cup x 1
• Installation Guide x 1
Model
Overview
The GV-GPS Receiver has two types of models. Each model can only work with appropriate
Hardware and Firmware version as described below.
Model
GV-GPS UART
GV-GPS 232
LED Off
LED On
LED Flashing
Receiver switched off
Signal searching
GPS position fixed
Interface
UART
RS-232
Baud Rate
9600
9600
H/W Version
GV-Video Server
Version 2.0 or later
GV-Compact DVR
Version 1.2 or later
Firmware Version
GV-Video Server
Version 1.43 or later
GV-Compact DVR
Version 1.52 or later
Black Wire : GND
LED
Model
Black Wire : GND
White Wire : RX
Red Wire : VCC
Green Wire : TX
GPS
Connecting to GV-Video Server
Connecting to GV-Compact DVR
2 4 6 8 10 12 14 16
1 3 5 7 9 11 13 15
Connect the appropriate wire(s) of GV-GPS UART to the
assigned pin on GV-Video Server Terminal Block as
described below.
GV-GPS UART
1 x Red Wire
2 x Black Wire
1 x White Wire
1 x Green Wire
GV-Video Server Terminal Block
Pin 9 (DC 5V Out)
Pin 10 (Ground)
Pin 12 (GPS RX)
Pin 14 (GPS TX)
GV-GPS 232
2 x Black Wire
1 x Green Wire
1 x White Wire
1 x Red Wire
GV-Compact DVR Terminal Block
Pin 10 (Ground)
Pin 12 (RS-232 TX)
Pin 14 (RS-232 RX)
Pin 16 (DC 5V Out)
Black Wire
X 2
White Wire
Red Wire
Green Wire
2 4 6 8 10 12 14 16
1 3 5 7 9 11 13 15
Black Wire
X 2
Green Wire
Red Wire
White Wire
Connect the appropriate wire(s) of GV-GPS 232 to the
assigned pin on GV-Compact DVR Terminal Block as
described below.
Model No:GV-GPS 232
S/N: X X X X X X
MADE IN TAIWAN
XXXXXXXXX XXXX XXXX XXXX
XXXXX XXX X X XXXX XXX
Model No:GV-GPS 232