9
Section 3: System Operation
System will display reading while powered ON.
The battery depletes after approximately 8 hours.
Recharge the system by turning the ON/OFF switch to the OFF position, unplug the
transducer, and plug in the power cable (provided with the unit) until the charging light
turns green.
Quick Start Guide
1) Plug in the wired transducer. Ensure wiring matches Figure 1-1
2) Turn the unit on with the ON/OFF switch.
3) Ensure to set the desired display units using steps 1-19 from the installation
section.
4) The unit is now ready for use.
Section 4: System Maintenance
Clean faceplate and case with mild soaps as needed.
Do not store in direct sunlight.
Charge battery before long-term storage
Summary of Contents for 4-20mA Display
Page 1: ...Rev 4 3 2019 Part 12050769 4 20mA Display Installation and Operation Manual...
Page 2: ......
Page 14: ...12 Notes...
