. IM010ES10
Page 9/28
5.2.
Cable connection
STEP 1.
Connect the camera cables to the base unit.
Up to three cameras can be connected to every base unit. Camera connectors are
marked with: “CAM1”, CAM2” and “CAM3”.
STEP 2.
Remove the magnet and check that all the LEDs are on (see image).
After checking,
place it back.
STEP 3.
Connect one end of the cable to the antenna and the other to the vessel AC power
supply.
Wait until all LEDs are on and then remove the magnet for good.
Power connectors are marked with: “PWR”.
A fuse must be inserted in the phase AC wire.
