GK-406-MUX - VW ANALYZER LOAD CELL MULTIPLEXER
| QUICK START GUIDE
Document Revision: A | Release date: 03/9/22
GK-406-MUX
VW Analyzer Load cell multiplexer - Quick Start Guide
SETUP
1.
Remove the protective silicon cover from the multiplexer and install the AA alkaline batteries (2) into the rear battery
compartment.
2.
Install the multiplexer back into the protective silicon cover.
3.
Connect the VW Analyzer to the multiplexer using the supplied cable.
4.
Connect the load cell to the multiplexer.
OPERATION (USING THE VW ANALYZER)
1.
Press the power button just under the left side of the readout screen on the VW Analyzer.
2.
Select or add a user and the home screen is displayed.
3.
Select
Read & Record
and then
Site/Sensor
to get a load cell reading.
4.
Select the load cell location or add a new location. There is an option add a default sensor to the new location.
5.
Select
Next
and then select the specific load cell model to be used or add the information as a new sensor.
6.
Select
Read
and the readout screen is displayed.
7.
Select
Details
in the readout screen to show more data. Select
Gauge
from the details screen
to toggle between the average
of all the vibrating wire sensors measurements in the load cell and the individual measurements of each sensor. Spectrum
and Time graphs are also available from the
Details
screen.
1:
1
Single 10-pin connector for load cell connection
2
Low battery indicator
3
2m VW Analyzer connector cable (included)
Power: (2) AA alkaline batteries (included)
2m VW Analyzer connector cable (included)
IP-40 rated case with silicone protective cover
Multiplexes all Geokon 3, 4 and 6 gauge VW load cells to use
the GK-406 VW Analyzer
1
2
3
