03/18
Due to ongoing product development details are subject to change without no ce
The Barn, Emmington,OX39 4AA | www.gentworks.co.uk | [email protected] | Ph. +44(0)1844
353210
BOTTLE FILLING STATION
WITH COMBINED DRINKING FOUNTAIN
MODEL
GW-951
INSTALLATION AND MAINTENANCE INSTRUCTIONS
THIS GUIDE DOES NOT COVER THE DESIGN OR INSTALLATON OF THE PLUMBING SUPPYLING THE DRINKING FOUNTAIN
Decide whereabouts the drinking fountain should be positioned. The drinking fountain requires a drainage connection and must
be connected to a potable (drinking quality) mains water supply.
The unit is fixed to the wall using a combina on of joggle brackets and screws which must be suitable for use on the wall
substrate.
•
Connect to water inlet using a ½” male thread. We recommend that an inline strainer (100 μm) is fiFed to catch grit or
other debris which may be in the water supply.
•
Connect waste outlet to waste water pipes.
•
Adjust feet to ensure level on floor.
•
Adjust the water flow using the screw in the lower part of the bubbler so that the water steam aims into the centre of the
bowl.
The flow rate for the boFle filler can be adjusted using the ball valve, whilst the water flow itself is triggered by a simple push
buFon valve.
If installed outside it is important to guard against frost. If water is allowed to freeze in the bubbler and / or boFle filler valves
permanent damage will be caused. Claims for internal mechanism damage cannot be accepted. As a further precau on it is
recommended to dismount the fountain and store it in an area where temperatures will not fall below freezing.
Provided that is carried out correctly and on a regular scheduled basis, you should find that the units give good performance and
a long service life.
Surface contamina on and the forma on of deposits must be prevented. Such deposits may contain minute par cles of iron leI
over from the installa on and not removed aIer the stainless steel items have been fixed. Industrial and even naturally occurring
atmospheric condi ons can produce deposits which can be equally corrosive, e.g. salt deposits in marine condi ons.
Maintenance and Frequency of Cleaning:
All grades of stainless steel can stain and discolour due to surface deposits and must never be accepted as completely
maintenance free. In order to achieve maximum corrosion resistance the surface of the stainless steel must be kept clean.
These drinking fountains are manufactured from grade 304 stainless steel and are not suitable for installa on in environments
such as swimming pool areas, where the chlorinated atmosphere will cause discoloura on of the stainless steel and internal
components.
When cleaning a specialist stainless steel cleaner is recommended. Do not use cleaning agents containing chlorine.
The frequency and cost of cleaning stainless steel is lower than for many other materials and this will oIen outweigh the fact that
stainless steel has a higher ini al cost. There are no hard or fast rules in regard to cleaning frequency but cleaning with
appropriate cleaning agents will restore the original appearance.
Technical Details
Water inlet:
½” female thread
Water pressure:
1—5 bar
Bowl diameter:
245mm
Waste outlet diameter: 40mm
Suitable BoFle sizes:
500, 750 or 1000ml
Weight:
12kg
Overall Dimensions:
330 x 365 x 900mm
(Adult height)
