GENMAX GM2800iA, User Manual, Page: 10 / 27

10
GM2800iAE/GM3500iAE/GM3500iAED
10
11
Parallel Connectors: To increase AC power output,
the connector sockets are used to connect the two
same type generator with special paralleling cords.
The connector sockets is only used to the
communication between the inverters, they cannot
used for AC power output. The special paralleling
cords shall be purchase separately, and they shall
be approved by certification body.
Efficiency Mode Switch: When turned to the ON
position, the engine will sense the load needed
and run at a slower RPM to save fuel.
Multifunctional LED Digital Display Meter: Red
light (LOW OIL) means that the amount of oil
is too low, red light (OVERLOAD) means that
the machine overload, green light (POWER)
means normal operation. LED Digital Display
shows time, voltage, power, frequency and oil
level; Time: scrolling display of single running
time and accumulated running time; voltage:
scrolling display of 120V and 240V.
USB Duplex: 5V DC that come in 1 amps and
2.1 amps.
AC Protector: If the inverter is overload, the AC
protector will trip to block current.
120-Volt, 30-Amp Outlet (L5-30): The outlet is
capable of carrying a maximum of 30 amps.
2
11
9
CO Alarm : Flashing red light: dangerous levels of
carbon monoxide gas have built up leave
immediately until area has aired out. Move generator
to well-ventilated area before operation. Flashing
yellow light: carbon monoxide sensor malfunction.
Sensor needs service.
10
4
One Push Start: Press this button, the engine
can start and stop. Press this button for 3-5
seconds until the green light is on, and then
press the ON/OFF button on the remote control
key until the light is off. At this time, the remote
control matches successfully.