GENMAX GM2000i, User Manual, Page: 9 / 24

9
GM2000i
11
10
AC Breaker:
to block current.
Parallel Connectors: To increase AC power output,
the connector sockets are used to connect the two
same type generator with special paralleling cords.
The connector sockets is only used to the
communication between the inverters, they can not
used for AC power output.
The special paralleling cords shall be purchase
separately, and they shall be approved by
certification body.
13
Choke Switch: when cold start, properly close part of
the air inlet to improve the engine start performance,
after normal operation, the choke should be fully
open, otherwise the engine can not run properly
because of too thick mixture and cause too much oil
consumption.
ENG.SW. ECO.SW.
OUTPUT
INDICATOR
OVERLOAD
ALARM
LOW OIL
ALARM
CO ALARM
CHOKE
AC 120V
NEUTRAL FLOATING
PARALLEL
CONNECTORS
AC BREAKER
AC RESET
DC 5V 1A/2.1A
SYSTEM FLOATING
11
12
10
13
12
CO Alarm: Flashing red light: dangerous levels of
carbon monoxide gas have built up leave
immediately until area has aired out. Move generator
to well-ventilated area before operation. Flashing
yellow light: carbon monoxide sensor malfunction.
Sensor needs service.
Fuel Switch
:
Fuel switch is OFF, and the engine will
not run.
14
Engine Switch: Press ON to start the engine, press
OFF to turn OFF the engine
14
Output Indicator: Indicates the inverter is
ready to be used.
Overload Alarm: Indicates that the inverter is
overloaded.
Low Oil Alarm: Indicates low oil level.