Genie S-60 HC, Service And Repair Manual

Page: 62 / 402

September 2016 Service and Repair Manual
Boom Components
Part No. 1268492 S-60 • S-65 • S-60 TRAX • S-65 TRAX • S-60 HC • S-60X • S-60XC 45
4-2 Boom
4-2
Boom
How to Remove the Boom
TIp-over hazard. This procedure
requires the removal of the
turntable counterweight. Failure
to remove the counterweight
before removing the boom
assembly will result in the
machine tipping over. Do not
remove the boom without first
removing the counterweight.
TIp-over hazard. When installing
the boom onto the machine, the
boom assembly must be first
installed prior to the installation of
the counterweight. If the
counterweight is installed before
the boom assembly, the machine
will tip over resulting in death or
serious injury.
TIp-over hazard. The turntable
counterweight is essential for
machine stability. Failure to install
the counterweight after installing
the boom assembly will
compromise machine stability
resulting in the machine tipping
over. Death or serious injury will
result.
Bodily injury hazard. This
procedure requires specific repair
skills, lifting equipment and a
suitable workshop. Attempting
this procedure without these skills
and tools could result in death or
serious injury and significant
component damage. Dealer
service is strongly recommended.
Note: Perform this procedure with the boom in the
stowed position.
Note: When removing a hose assembly or fitting,
the O-ring (if equipped) on the fitting and/or hose
end must be replaced. All connections must be
torqued to specification during installation. Refer to
Specifications,
Hydraulic Hose and Fitting Torque
Specifications.
1 Remove the jib boom. Refer to Repair
Procedure,
How to Remove the Jib Boom .
2 Remove the cable track. Refer to Repair
Procedure,
How to Remove the Cable Track .
Note: S-60X and S-60XC: Disconnect the two limit
switch connectors at the platform end of the cable
track.
3 Raise the boom until the short and long link
arm to boom pivot pins are above the
turntable covers.
4 Place a block of wood measuring 4 x 4 x
60 inches / 10 x 10 x 152 cm under the long
link arm, across the turntable covers.
5 Slowly lower the boom until the long link arm
contacts the wood block. Do not rest the entire
weight of the boom on the block. Turn the
machine off.
Component damage hazard. The
turntable covers can become
damaged if the weight of the
boom is allowed to rest on the
block.
6 Place wood blocks between the short link arm
and the turntable weldment for support.