INTELLICODE SERIES II TRANSMITTER
GIT90-1, GIT90-2, GIT90-3
1.
IMPORTANT INFORMATION
USE ONLY WITH SERIES II ELECTRONICS.
Older Transmitters and Receivers will not work with the new electronics. There are no Security Code Switches inside Door Operators, Transmitters
and Receivers.
************* WARNING *************
Moving Door can cause serious injury or death.
•
DO NOT install transmitter unless the door operator’s
works as required by the door operator’s manual.
safety reverse
•
Wall control must be mounted in sight of door, at least 5 feet above floor and clear of moving door parts.
•
Keep people
clear of opening while door is moving.
•
DO NOT
allow children to play with the transmitter or door operator.
If
does not work properly:
safety reverse
•
Close door then disconnect operator
using the manual release handle.
•
DO NOT
use transmitter or door operator.
•
Refer to Door and Door Operators Owner’s Manuals before attempting any repairs.
_________________________________________________
Electrical Shock can cause serious injury or death.
Power cord must be unplugged before attaching any wires,
•
Be sure wire ends do not touch each other or other terminals.
•
If you have questions or if you need a manual, contact the distributor or manufacturer of the operator.
******************************************************************************************************************************
A different Transmitter Code is set at the factory for each SERIES II INTELLICODE Transmitter.
2.
TO PROGRAM THE RECEIVER
This can be found
where you see the antenna wire hanging from the motor head (you may have to take the lens cover off). If antenna wire is not hanging from
motor head then you have an external receiver which is a black box approx. 6" x 2" mounted somewhere in the garage with a antenna wire
hanging from it (pop off cover to find Learn Code Button).
•
Locate the Learn Code Button and Radio Signal Indicator on the Power Head Receiver of your Door Operator.
The Radio Signal Indicator will blink approximately 2 times per second.
•
Press and release the Learn Code Button.
The Radio Signal Indicator stays lit
•
Press the Transmitter Button once within 30 seconds.
– SOLID.
The Radio Signal Indicator will go out ( the Transmitter Code ins now stored in
memory).
•
Press the Transmitter Button once within 30 seconds.
If a second Transmitter Code is not confirmed within 30 seconds or if a different Transmitter Code is sent, the Radio Signal Indicator will blink
approximately 4 times per second, then programming will stop. If programming stops, repeat all steps again.
NOTE:
•
Repeat all steps for each Transmitter, Wireless Keypad or other access device to be learned.
If a Transmitter becomes
lost or if you want to delete a Transmitter, Wireless Keypad or other access device, proceed to
NOTE: A maximum of 7 Transmitter, Wireless Keypad and other access device Codes can be stored in Receiver Memory.
ERASING ALL RECEIVER MEMORY.
(1) Erase ALL Transmitter Codes from the Receiver memory. (2) Reprogram the Receiver with
the remaining Transmitters Codes.
NOTE: If you are replacing a lost or stolen Transmitter:
3.
MULTI-BUTTON TRANSMITTERS
Only ONE button of a Multi-Button Transmitter can be programmed into a single Receiver. The other buttons are to control other Door Operators.
NOTE:
4.
ERASING ALL RECEIVER MEMORY
•
Press and HOLD the Learn Code Button for 10 seconds or until Radio Signal Indicator goes out.
•
ALL TRANSMITTER CODES ARE ERASED FROM RECEIVER MEMORY.
•
Reprogram the Receiver with the remaining Transmitter Codes by repeating all steps in number 2.
5.
BATTERY / VISOR CLIP INSTALLATION
•
Turn Transmitter upside down.
Intellicode Remote Coding Instructions GIT series.
