User Manual
Rocket 4D Evaporation System
04-7848 Issue 2-4 August 2014
11
Getting Started
Batch mode
Feed mode
To start Rocket 4D in batch mode:
1.
Check / top-up the chamber water level.
2.
Load the evaporation vessel into the
evaporator (do this before adding
product solution).
3.
Fit the batch baffles.
4.
Pour the product solution into the
evaporation vessel. Take care to avoid
product solution entering the holes in the
hub.
5.
Fit the inner lid seal.
6.
Fit the inner lid.
7.
Close the main lid.
8.
Make sure a waste solvent container is
connected and has sufficient capacity.
9.
Select the appropriate batch mode
method and press the start button
.
Note: For smaller volumes (two litres or less)
the feed baffle may be used instead of the
batch baffles.
To start Rocket 4D in feed mode (feed
enabled systems only):
1.
Check / top-up the chamber water level.
2.
Load the evaporation vessel into the
evaporator.
3.
Place the feed baffle in the evaporation
vessel (batch baffles should not be
fitted).
4.
Fit the inner lid seal.
5.
Fit the inner lid.
6.
Close the main lid.
7.
Pour the product solution into the
product solution reservoir.
8.
Insert the product solution feed hose
into the product solution reservoir, make
sure the hose weight reaches the
bottom of the reservoir.
9.
Pour the rinse solvent into the rinse
solvent reservoir.
10.
Insert rinse solvent feed hose into the
rinse solvent reservoir, make sure the
hose weight reaches the bottom of the
reservoir.
11.
Check a waste solvent container is
connected and has sufficient capacity.
12.
Select the appropriate feed mode
method and press the start button
.