7.6
Feet
GEN3t stands on four rubber feet in normal operation position. Two feet are
positioned at the rear and two are at the front of the instrument. Two extra,
foldable front feet can be used to lift the instrument front so the side panel angle
is towards the user. The angle between side panel and vertical axis is about
+8 ° in this position.
7.6.1
To turn the feet out:
1
Put the instrument on a flat surface.
2
Lift the instrument front.
3
Pull out the front feet by turning the back of the feet towards the front of the
instrument.
4
Gently put down the GEN3t front and it will stand on its feet.
Figure 7.13:
GEN3t stand on feet out
7.6.2
To turn the feet in:
1
Put the instrument on flat surface.
2
Slightly lift the instrument front.
3
Push in the front feet by turning the feet towards the back.
4
Gently put down the GEN3t front.
GEN3t
I3995-3.1 en HBM: public
101