Installation Instructions
CONGRATULATIONS!
You have just purchased a General
Ecology, Inc. SEAGULL
®
IV X-6 Water Purification System
employing the most advanced, effective and reliable
technology available. The features of this equipment are
indicated in product literature accompanying each Unit. It
is recommended that you briefly study this literature
before beginning your installation. Please note that the
SEAGULL
®
IV X-6 Unit features top mounted, NPT
threaded ports that are available in either ¾ or 1 inch
sizes. Be sure you have the proper size for your
installation (normally ¾ inch for residential applications).
Sweat-type copper inlet and outlet adapter/connectors are
also available upon request.
Multiple Units can be installed in parallel to increase flow
rate (for industrial, commercial and special applications),
or in series for special requirements such as pre-filtration
followed by submicron microfiltration (
Figure 1).
Installation is straightforward and is easily accomplished
by persons experienced in plumbing installation. A ½"
“deep” socket will facilitate V-clamp Nut removal and
replacement and is recommended.
Series Installation
SUPPLY (IN)
Use same pipe sizes throughout.
Figure 1
SUPPLY (IN)
SERVICE (OUT)
SERVICE (OUT)
1½" LINE
Parallel Installation
Made in the USA
SEAGULL
®
IV X-6
DRINKING WATER
PURIFICATION SYSTEM
INSTALLATION AND
PRODUCT USE GUIDE
AS9100, ISO 9001 and FAA Quality Certified Original Equipment and PMA Manufacturer
