Generac Power Systems OHVI GSH 190, Service Manual

Page: 32 / 72

7-2
SeCTIoN 7: rewINd STArTerS
dISASSeMblY (old STYle)
. Pry up the HANDLE INSERT, to expose knot in ROPE (see
Figure 7-2).
2. Untie knot in ROPE. Remove HANDLE INSERT and
HANDLE.
. Slowly release spring tension on the PULLEY, after the rope
has been drawn through the HANDLE.
. Remove the CENTER RETAINING SCREW. Then, remove
the RETAINER PAWL, STARTER DOGS, DOG SPRINGS, and
SPRING.
5. Lift out the PULLEY.
reASSeMblY
. Place SPRING and SPRING KEEPER into position, turn to
lock into position (see Figure 7-2). The spring should be
lightly coated with grease.
2. Place the PULLEY, along with SPRING and SPRING KEEPER,
into the HOUSING. Install SPRING, STARTER DOGS and
DOG SPRINGS.
. Install retainer PAWL and SCREW.
. Wind the pulley counterclockwise until tight, generally
three to four turns. Then, allow it to unwind until the hole
in the pulley lines up with the eyelet in the housing.
5. Pull the rope up through the eyelet in the housing, then
through the HANDLE and HANDLE INSERT. Tie a left-hand
knot in the rope (see Figure 7-2).
6. Install the HANDLE INSERT into the HANDLE.
7. Test the starter for proper operation.
dISASSeMblY (New STYle)
Disassembly of new style rewind starter is not cost effective,
except for ROPE or HANDLE replacement (see Figure 7-).
Installation of the rope on the pulley is the same as for the
OLD STYLE.
Figure 7-3. Exploded View of Rewind Starter (New Style)
0C1103Arev0.indd 2 6/22/2006 10:51:00 AM