Generac Power Systems MAGNUM MLT4060MVD, Owner'S Manual

Page: 45 / 72

Maintenance
Owner’s Manual for MLT4060MVD Light Tower 41
Resetting Maintenance Alarms
The Power Zone–DLA will display a warning message
when the unit is due for maintenance or service. The
maintenance or service interval is set at 750 hours of
engine running time. Once the unit has been serviced,
the appropriate maintenance alarm reminder needs to be
reset. The following procedure demonstrates how to
reset the maintenance alarms:
1.
With the unit shut down, move the control power
switch to ON (I). After initialization, the controller
will toggle automatically to the Home screen.
2.
Press
↑
or
↓
simultaneously to enter the navigation
menu.
3.
Press
↑
or
↓
to move to the top of the screen.
Press

to enter the Maintenance screen.
4.
Press
↑
or
↓
to highlight the desired alarm that
needs to be reset. Press

to start reset.
5.
Enter the pin 4444. To do this, press  and then
↑
or
↓
to adjust the first number of the maintenance
pin. Press  to continue to the next number.
Figure 4-1. Enter Maintenance PIN
NOTE: For further information on adjusting controller
settings, contact GMP Technical Service at 1-800-926-
9768.
Winch Use, Operation and
Maintenance—Manual
Prior to Use
•
Inspect rope or cable and replace if damaged.
•
Check mounting hardware for proper tightness
and re-torque if necessary.
•
Gears, ratchet pivot point and shaft bushings
must be kept lubricated with a thin film of oil or
grease.
Operation
Raising the Lights:
1.
The cable must be securely fastened to the object
being lifted and to the winch drum.
2.
Verify the cable and cable attachments are not
damaged. Contact Generac Mobile Products to
order a replacement cable if necessary.
3.
Referring to the “Lift / Let Down” decal on the
winch, turn handle according to the specified
direction to lift. The ratchet MUST make a loud
clicking sound while winding the cable.
Lowering the Lights:
Referring to the “Lift / Let Down” decal on the winch, turn
handle according to the specified direction to lower. No
clicking will be heard because the brake system is
activated.
Maintenance
The following procedures should be performed at least
annually:
1.
The gears and bushings of the winch must be kept
lubricated. Apply a thin film of grease to the gear
teeth, and oil the bushings as needed.
2.
The ratchet pawl pivot point must be kept
lubricated with a thin oil.
NOTE: Do not get oil or grease on the brake mechanism.