Generac Power Systems GC1000S, Owner'S Manual

Page: 17 / 72

Owner’s Manual for 10 Ton Kinetic Splitter 13
Maintenance
Section 4: Maintenance
Maintenance Schedule
WARNING
Risk of injury. Do not operate or service this machine
if not fully alert. Fatigue can impair the ability to
service this equipment and could result in death or
serious injury.
(000215)
(000419)
CAUTION
Personal injury. Wear appropriate personal protective
equipment at all times while operating and servicing
unit. Failure to do so could result in personal injury.
Table 4-1. Regular Maintenance Checklist
Procedure Before Each Use Every 5 Hours Every 25 Hours
Check general equipment condition 
Perform rail maintenance 
Check belt 
Check the condition of the electrical cord 
Grease rack 
Clean motor exterior and cooling fins. 
Lubrication
All bearings are sealed units and should have sufficient
lubricant to last the life of your machine with normal use.
Perform machine lubrication per the following instruc-
tions.
Rail Maintenance
See Figure 4-1 . Between each use, remove any debris
caught on the rail (A) or ram (B) and applying a rust pre-
ventative to any bare metal areas on the top of the rail.
This will assure the smoothest return action of the ram.
010951
A
B
Figure 4-1. Rail Maintenance
WARNING
(000719)
Personal Injury. Before performing any maintenance
or service on this unit, shut off the motor, unplug the
power cord and wait five minutes for the unit to cool.
Failure to do so could result in serious injury.