GemOro Superior Instruments
8
COMPLETE OPERATING INSTRUCTIONS
–
Steps 1 through 12
(WARNING: DO NOT PLUG IN OR TURN ON UNTIL YOU REACH
STEP 5).
1. Place the BrilliantSpa Black Diamond upright on a flat, dry, level
surface near the edge of a sink or counter. Alternatively, you may
place it on your counter with the steam residue mat positioned in
front of the steamer, under the steam nozzle.
2. Be certain the stainless steel mesh basket is installed into the
slot located under the steam nozzle. Insert the basket firmly,
while being sure to press hard enough to be certain it is installed
securely and completely.
3. With the steamer unplugged and sufficiently cool, slowly and
carefully unscrew the fill cap and then remove it. There is a built-in
safety feature that prevents the fill cap from being removed before
it is cool enough. If used previously, remove any remaining water
in its tank by turning it upside down over a sink. Fill the measuring
cup with undiluted tap water to the 5oz mark and slowly pour it
into the steamers funnel. For the driest steam, fill the measuring
cup with an additional 5oz of water and pour it into the funnel,
totaling 10oz. To reach the maximum capacity, instead of adding
5oz, fill the measuring cup to the 6oz mark and slowly pour it into
the funnel, totaling 11oz. Always use the supplied water fill cup
or a proper measuring cup and do not attempt to estimate the
amount of water being added or over filling may occur.
4. Replace the water fill cap by hand tightening. Do not over-tighten.
Over-tightening could result in damage to your fill cap gasket and
consequently your steamer will not pressurize properly.
5. Plug in the BrilliantSpa Black Diamond to a grounded electrical
outlet that has a power rating sufficient to operate the product.
Locate the switch on the power cord and flip it to the “I” position to
turn it on. Within approximately 3 minutes it will automatically heat
up the water in its tank creating pressurized steam. The red LED
light will indicate that the steamer is heating up the water in its tank
and building pressure.
