PAGE 3
To prevent problems with the remote control, it has been provided with a device that will signal the
charge condition of the batteries inside.
During normal use of the remote control, when you press a command button the green LED will light
up with a steady light.
If the batteri
.
For battery replacement follow the indications reported below
es are too weak for normal operation of the remote control, when the button is pressed the
green LED will start blinking, advising you that it is time to replace the batteries
3.0 - REMOTE CONTROL BATTERIES REPLACEMENT
.
Separate the
plastic shells of
the remote
control, paying
attention to not
damage the
internal circuit.
Remove the discharged
batteries and insert the new
batteries in their housing, taking
care not to invert the polarity.
Close the
plastic shells
of the remote
and verify the
remote control
works
properly.
BATTERIES
Use only batteries of Cr1616 type.
Discard used batteries properly in special dedicated containers.
WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT
(WEEE) DIRECTIVE
In the European Union, this lable indicates that this product must not be disposed of with household
waste. It should be deposited at an appropriate facility to enable recovery and recycling (directive
2002/95/CE, 2002/96/CE and 2003/108/CE).
For information on how to recycle this product responsibly in your Country, please visit the web-site:
Www.eur-lex.europa.eu
WARRANTY CONDITIONS
e
t
a
d
n
o
it
a
ll
a
t
s
n
i
e
h
t
m
o
rf
s
h
t
n
o
m
4
2
s
i
h
T
shown on this warranty coupon, taking into consideration the 1999/44/CE.
Therefore, you are kindly requested to fill entirely the guarantee certificate included in this booklet and
to NOT REMOVE the guarantee label from the device.
product is guaranteed to be free from manufacturing defects
The warranty will become void if labels are missing or torn, if the installation certificate is not fully
compiled or if the enclosed sale document is missing.
The guarantee is valid exclusively at authorized Gemini Technologies S.p.A. Service Centers.
The manufacturer declines any responsibility for eventual malfunctions of the device or any damage
to the vehicle electrical system due to improper installation, use or tampering.