Gemalto CINTERION DSB-Mini, User Manual

Page: 16 / 30

DSB-Mini User Guide
3.6 Application Connectors
23
c
dsb-mini_ug_v02 Page 16 of 30 2012-10-09
Confidential / Released
3.6 Application Connectors
The DSB-Mini has a number of connectors for various purposes as described in the sections
below.
3.6.1 2x40-Pin Connector for Starter Kits
The 2x40-pin connector can be employed to mount any Cinterion Starter Kit with a plugged
module. All module signals are then available at the 80-pin connector (see
Section 3.6.2 ) or the
additional 10-pin connector (see Section 3.6.4 ) for signal measurement or to connect further
external applications.
The below table shows the pin assigment for the 2x40 pin connector. Not all of the listed pins
will be available with every Cinterion module. Please refer to the "Hardware Interface Descrip-
tion" of your module for the supported signals.
Table 6:
2x40 pin connector pin assignment
Connector A Connector B
DAI7 1 40 DAI0 BATT+ 41 80 BATT+
DAI6 2 39 DAI1 GND 42 79 GND.DETECT
DAI5 3 38 DAI2 AGND 43 78 GND
DAI4 4 37 DAI3 USB_DN 44 77 VUSB
SPI_DI 5 36 SPI_CLK USB_DP 45 76 VEXT1
SPI_DO 6 35 SPI_CS VEXT2 46 75 3V0
I2CDAT 7 34 I2CCLK 5V0 47 74 VMIC
N/C 8 33 DCD0 EPP1 48 73 EPN1
EMERG_RST 9 32 CTS1 EPP2 49 72 EPN2
RXD1 10 31 CTS0 MICP1 50 71 MICN1
RXD0 11 30 RTS1 MICP2 51 70 MICN2
TXD1 12 29 DTR0 TTY_EP 52 69 TTY_MIC
TXD0 13 28 RTS0 GPIO10 53 68 GPIO1
ADC1 14 27 DSR0 GPIO9 54 67 GPIO2
ADC2 15 26 RING0 GPIO8 55 66 GPIO3
DAC 16 25 STATUS2 GPIO7 56 65 GPIO4
STATUS/SYNC 17 24 VDDLP GPIO6 57 64 GPIO5
PWR_IND 18 23 IGT CCCLK 58 63 CCRST
GND 19 22 GND CCIO 59 62 CCIN
GND 20 21 GND CCVCC 60 61 CCGND